Instructions / Assembly
4
Installation
1
Identifying the Wires
□ Turn OFF the main power at the circuit breaker
before installing the fixture.
□ Identify the wiring: (black - line voltage, white - neutral
and green - ground)
2
Attaching the Mounting Plate
□ Attach the mounting plate (AA) to the junction box
using the two #8-32 x 1 in. screws (DD) provided.
□ Align the mounting plate in the direction you want
the fixture to be aligned. Once the toggle bolts are
installed, you cannot change the orientation.
3
Positioning the Toggle Bolts
4
Securing the Toggle Bolts
5
Re-attaching the Mounting Plate
6
Connecting the Panel Light
7
Installing the Panel Light
□ Using the mounting plate (AA) as a guide, mark the
position of the holes on the ceiling or wall where the
toggle bolts will be placed.
□ Remove the mounting plate (AA) from the junction box.
□ Hook the support wire from the fixture on the
mounting bracket plate.
□ Connect the three wires coming from the fixture to
the junction box wires (black - line voltage, white -
neutral and green - ground).
□ Drill four holes where marked using a 1/2 in. drill bit.
□ Remove the wings from the 3/16 in. toggle bolts (BB).
□ Insert a screw (BB) through the front of the mounting
plate (AA) and reattach the wing to the screw (BB).
Repeat for all four toggle bolts.
CAUTION: When installing the panel on a vertical surface, the
mounting plate must be installed in such a way that the mount-
ing tabs are oriented in a vertical position. If the mounting tabs
are not in this position the fixture will not be properly secured
and could fall resulting in serious injury.
CAUTION: Care must be taken not to have excess wires
outside the junction box to avoid pinching wires. This
may cause a short and could lead to a potential hazard.
line voltage
ground wire
neutral
AA
DD
BB
□ Feed the junction box wires through the center of
the mounting bracket plate (AA) hole.
□ Re-attach the mounting plate (AA) by inserting the
four toggle bolts (BB) into the drilled holes.
□ Once the wings (BB) are through and expanded, pull
the screw (BB) downward to engage and tighten.
1
2
AA
BB
AA
AA