Installation Guide
2
Table of Contents
Safety Information ..................................2
Warranty ..........................................2
Pre-Installation .....................................3
Preparing for Installation .............................5
Installation ........................................5
Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Care and Cleaning ..................................9
Troubleshooting ....................................9
Safety Information
IMPORTANT
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE
APPLICABLE NATIONAL ELECTRICAL CODE AND LOCAL BUILDING
CODES BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND
OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
PRECAUTIONS
□ Please read and understand this entire manual before
attempting to assemble, install, or operate this light xture.
□ This light xture requires a 120–277 Volt AC power source.
□ Some codes require installation by a qualied electrician.
□ This light xture must be properly grounded.
□ Make sure connections are secure using wire nuts, crimp-on
lugs or other UL approved connecting devices.
□ This light xture should be installed outdoors to a wall.
□ This product may contain chemicals known to be hazardous.
Thoroughly wash hands after installing, handling, cleaning or
otherwise touching the product.
NOTICE: Do not connect this xture to a dimming switch.
NOTICE: FCC Regulations state that any unauthorized changes
or modications to this equipment not expressly approved by the
manufacturer could void the user’s authorization to operate this
equipment.
WARNING: Before installation or servicing, turn the power
OFF at the circuit breaker or fuse. Place tape over the circuit
breaker switch and verify power is OFF at the light xture.
WARNING: Risk of re. Keep the lamp heads at least 3 in.
(76 mm) from combustible materials.
CAUTION: Burn hazard. Allow the light xture to cool
before touching.
IMPORTANT: This equipment has been tested and
found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning
the equipment OFF and ON, the user is encouraged to try
to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
Warranty
This is a limited warranty offered by the manufacturer for a period of ve years from the date of purchase to its customers. The
manufacturer warrants to customers that the products will be free from defects in material and workmanship. The obligation of the
manufacturer under this warranty is limited to the provision of replacement of products and is extended to the original purchaser of the
product on presenting valid purchase receipt or other proof of date of original purchase acceptable to the manufacturer. The receipt is
required for rendering the warranty performance. Any warranty claims without original proof of purchase would not be accepted.
It should be noted that the warranty does not apply to the manufacturer products that have been altered or repaired by unauthorized
personnel, have been subjected to neglect, abuse, misuse or accident or damages caused during shipping. Any other products not
manufactured by the manufacturer which have been supplied, installed and/or used in conjunction with the manufacturer products are not
covered under this warranty. Any damages caused by replacements bulbs, LEDs or corrosion or discoloration of brass components are also
not covered by this warranty.