Installation Guide

7 HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
Installation (continued)
4
Drilling mounting holes in concrete/
brick wall
If you are installing the mounting system into wood studs, proceed
to step 5.
CAUTION: Avoid drilling near electrical wiring and water
pipes. The mounting system must be attached to a weight
bearing wall. Failure to observe all safety precautions can
result in serious physical injury and/or property damage.
Consult a professional installer or call customer service if
you have any questions.
CAUTION: Do not drill into mortar between bricks or into
loose concrete.
CAUTION: Never drill into hollow brick.
□ Use 3/8 in. masonry bits to drill mounting holes in the
concrete approximately 2.50 in. (6.35 cm) in depth.
□ Insert nylon anchors (AA) into the pre-drilled holes. You
may have to use a hammer to gently tap the anchors fully
into the wall.
Masonry
Drill Bit
5
Drilling mounting holes in wood studs
CAUTION: Avoid drilling near electrical wiring and water
pipes. The mounting system must be attached to a weight
bearing wall and must be installed directly onto the center
of the wood studs. Failure to observe all safety precautions
can result in serious physical injury and/or property
damage. Consult a professional installer or call customer
service if you have any questions.
CAUTION: Wood studs must be no smaller than 2 x 4 in.
in size.
□ Use a commercially-available stud nder to locate the stud
centers in the wall. Studs are usually spaced 16 in. apart.
□ Use 7/32 in. (5.5 mm) wood drill bit to drill holes to a depth
of 2.50 in. (6.35 cm).
Wood
Drill Bit
6
Attaching the mounting arm to the
wall
□ Align the mounting arm holes with the pre-drilled holes in
the wall.
□ Attach the mounting arm (A) to the wall using lag bolts
with washers (BB). Tighten the bolts (BB) securely using a
Phillips screwdriver and a socket tool (not included).
A
UP
BB