Installation guide

Introduction 1-5

Compaq Confidential – Need to Know Required

Writer:

John Turner

Project:

Compaq 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter Installation Guide

Comments:

final

Part Number:

154060-002

File Name:

b-ch1 Introduction.doc

Last Saved On:

7/21/00 1:21 PM

CAUTION:

To prevent boot error messages, the integrated SCSI controller on

the system board of the server must be terminated at all times. If you are using

the 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter to replace the

integrated controller, you should leave a terminated SCSI ribbon cable

connected to the system board, even if there are no SCSI devices attached to

this cable.

SCSI Cables

Cables are provided with most Compaq server products that require cabling. If

you find that you need an additional cable or that one was not provided with

your server product, you can order the necessary cables from your local

Compaq Reseller or authorized Compaq Service Provider. See Table 1-1 for

external cable option kit part numbers.

Table 1-1

Compaq External Cable Option Kit Part Numbers

Cable Option Kit Part Number Alternate Part Number

VHDCI to Wide SCSI 6 foot 341176-B21 295644-B21

VHDCI to Wide SCSI 12 foot 341177-B21 295645-B21

Wide SCSI to Wide SCSI 6 foot 313375-001

Wide SCSI to Wide SCSI 12 foot 313375-002

NOTE:

An internal 68-pin to 50-pin SCSI adapter (part number 199618-001) is also

available.

If the option kit part number for the cable you need is not listed here, or for

additional ordering information, refer to the Compaq website at