Installation guide

2-2 Compaq 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter Installation Guide
Compaq Confidential – Need to Know Required
Writer:
John Turner
Project:
Compaq 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter Installation Guide
Comments:
Part Number:
154060-002
File Name:
c-ch2 Installing the Adapter.doc
Last Saved On:
7/21/00 1:30 PM
Preparing the Server
Use the following general guidelines to prepare the server for installation of
the 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter.
WARNING:
When working with equipment installed in a rack, be sure that the
equipment/rack is stable before beginning.
To prepare the server:
1. Perform a normal system shutdown.
2. Turn OFF the server.
3. Turn OFF all peripheral devices attached to the server.
4. Unplug the AC power cord from the outlet, then unplug it from the
server.
5. Disconnect all peripheral devices attached to the server.
Opening the Server
Before installing 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter,
you must open the server and gain access to the PCI bus expansion slots. For
instructions on opening the server and accessing the PCI slots, refer to the
documentation that came with your server.
After you have accessed the PCI slots, proceed to the next section, “Installing
the 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter.”
Installing the 64-Bit/66 MHz Single
Channel Wide Ultra3 SCSI Adapter
Use the following general guidelines to install 64-Bit/66 MHz Single Channel
Wide Ultra3 SCSI Adapter in a Compaq server.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the
internal system components to cool before touching.
CAUTION:
Electrostatic discharge (ESD) can damage electronic components. Be
sure you are properly grounded before beginning this procedure. See Appendix
B for ESD information.