Installation guide

2-4 Compaq 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter Installation Guide
Compaq Confidential – Need to Know Required
Writer:
John Turner
Project:
Compaq 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter Installation Guide
Comments:
Part Number:
154060-002
File Name:
c-ch2 Installing the Adapter.doc
Last Saved On:
7/21/00 1:30 PM
Figure 2-1. External SCSI cabling on a Compaq server
To connect to a wide Ultra3 SCSI peripheral, use a standard Wide SCSI-Wide
SCSI cable.
If this cable is not furnished with your Compaq external SCSI device, it can be
obtained from your local Compaq Reseller. See “SCSI Cables” in Chapter 1
for information on ordering the correct cables.
To attach the cable:
11. Attach the appropriate end of the cable to the external peripheral
according to the instructions that came with the device. Make sure to
secure the thumbscrews.
12. Attach the cable to the adapter and secure the thumbscrews.
After your cabling is complete, proceed to “Completing the Installation,” later
in this chapter.
Internal SCSI Connections
Use the information in this section to connect the 64-Bit/66 MHz Single
Channel Wide Ultra3 SCSI Adapter to internal SCSI devices. The most
common cabling scenarios include:
■
Placing hard drives or other devices on a separate SCSI bus
■
Replacing the integrated SCSI controller with 64-Bit/66 MHz Single
Channel Wide Ultra3 SCSI Adapter
■
Connecting additional internal SCSI devices