Installation guide

Installing the Compaq 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter 2-7
Compaq Confidential – Need to Know Required
Writer:
John Turner
Project:
Compaq 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter Installation Guide
Comments:
Part Number:
154060-002
File Name:
c-ch2 Installing the Adapter.doc
Last Saved On:
7/21/00 1:30 PM
3. Route the cable(s) according to the instructions in your server
documentation.
4. Attach the cables to the new SCSI devices.
Completing the Installation
After all cabling and connections have been completed, reassemble the server
by following these guidelines:
1. Be sure all cables are routed correctly and are not restricting or being
pinched by other components. Refer to your server documentation for
proper routing of the cables for your server model.
2. Reconnect any peripheral devices to the server.
3. Plug the AC power cord into the server, then into a grounded AC outlet.
4. Turn on any peripheral devices attached to the server.
5. Turn on the server.
6. Run the Compaq System Configuration Utility to enable the system to
recognize the new SCSI adapter configuration. You can run this utility
from the System Configuration diskettes, Compaq SmartStart and
Support Software CD, or from your hard drive (if it was previously
installed in the system partition of your boot hard drive).
Updating the Firmware and Installing the Drivers
Software drivers must be installed in the server to enable communication
between the processor and the new 64-Bit/66 MHz Single Channel Wide
Ultra3 SCSI Adapter.
Some Compaq servers also require updated system ROM firmware before they
can take advantage of the new features of 64-Bit/66 MHz Single Channel
Wide Ultra3 SCSI Adapter. Compaq recommends running the System
ROMPaq Utility to be sure your server has the latest ROM version. For more
on this, see “Upgrading the System ROM,” in Chapter 3.
Proceed to Chapter 3, “Installing Firmware and Software,” to install the
necessary drivers for your operating system and model.