Installation guide

3-8 Compaq 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter Installation Guide
Compaq Confidential – Need to Know Required
Writer:
John Turner
Project:
Compaq 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter Installation Guide
Comments:
Part Number:
154060-002
File Name:
d-ch3 Installing Firmware and Software.doc
Last Saved On:
7/21/00 2:23 PM
6. Press Tab to highlight the software selections, and use the arrow keys to
highlight Compaq Extended Feature Supplement. Press Enter.
7. Press Tab to go back to the menu bar. Choose Software and press
Enter.
8. Choose Remove Software and press Enter.
9. You are prompted to verify the removal of all packages. Choose
Remove and press Enter.
10. When all the EFS packages have been removed, a message will display
that the kernel was relinked. Press Enter to continue.
11. At the message
Removal Complete
, press Enter to continue.
12. Exit the installation procedure:
a. Choose Host and press Enter.
b. Choose Exit and press Enter.
13. Continue with the step 5 of the procedure described in the next section
to install a new version of EFS.
WARNING:
DO NOT reboot the system before installing the new EFS version.
Omit the first four steps of the procedure in the following section.
Installing the New EFS
1. Log in as root.
2. Enter
/etc/shutdown -g0 -y
to shut down the system.
3. At the Safe to Power Off message, press Enter.
4. When the system reboots, you will see the prompt
Press <Ctrl>+<d> or enter the root password.
Enter the root password to begin system maintenance mode.
5. Type
/etc/custom
and press Enter.
The main custom menu should appear.
6. Choose Software (on the menu bar) and press Enter.
7. Choose Install New and press Enter.
8. You will be asked what host you want to install from. Select the local
host and press Enter.
NOTE:
Only the local host is supported.