Installation guide

Installing the Firmware and Software 3-9
Compaq Confidential – Need to Know Required
Writer:
John Turner
Project:
Compaq 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter Installation Guide
Comments:
Part Number:
154060-002
File Name:
d-ch3 Installing Firmware and Software.doc
Last Saved On:
7/21/00 2:23 PM
9. Insert diskette Volume 1 of the Compaq EFS for SCO OpenServer
Release 5 into the diskette drive.
10. Choose Continue and press Enter.
The initial EFS screen appears. Each component of the EFS is listed
below the title as it is installed.
11. When prompted, enter the IP address, broadcast address, and network
mask for each installed network controller.
12. When prompted, insert diskette Volume 2 of the Compaq EFS for SCO
OpenServer Release 5 into the drive and press Enter.
13. When installation of the drivers and utilities is complete, the following
message is displayed:
During this installation, the kernel was relinked.
You must reboot your system to make this kernel effective. Press
Return to continue.
14. When the message
Installation Complete
is displayed, press Return.
EFS should be on the All Software On... list when rebuilding has
finished.
15. Exit the installation procedure:
a. Choose Host and press Enter.
b. Choose Exit and press Enter.
16. At the # prompt, enter
reboot.
Novell NetWare 5.1
This section describes how to install the 64-Bit/66-MHz Single Channel Wide
Ultra3 SCSI Adapter driver on a system already running Novell NetWare 5.1.
The driver file, named ADPT160M.HAM, can be found in the following
subdirectory on the SmartStart and Support Software CD:
\CPQSUPSW\NSSD\NWPA
Use the following steps to install the driver ADPT160M.HAM and the file
ADPT160.DDI from the SmartStart and Support Software CD onto a system
running NetWare 5.1.
1. Use the
down
command to down the server.
2. Power on the system and start NetWare 5.1.