Installation guide

Installing the Firmware and Software 3-11

Compaq Confidential – Need to Know Required

Writer:

John Turner

Project:

Compaq 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter Installation Guide

Comments:

Part Number:

154060-002

File Name:

d-ch3 Installing Firmware and Software.doc

Last Saved On:

7/21/00 2:23 PM

Select Compaq OS/2 Support Software - 4.50A Or Later Version and

move to the next screen.

Chose the option Create Software Diskettes To Floppy Only, then click

through the following screens until a screen indicating Please Insert

Diskette 4 Of 5… is displayed.

Insert a formatted 1.44 MB diskette into the diskette drive and click OK.

The drivers related to the 64-Bit/66-MHz Single Channel Wide Ultra3

SCSI Adapter Controller will be copied onto the diskette.

Click Finish when done.

Exit from the application.

Insert the floppy diskette 4 into the floppy drive.

10.

At the command prompt, type

ddinstal

11.

Select A:\ADD as the source directory and select Install.

12.

Select Compaq Adaptec SCSI Driver for OS/2 and proceed. This will

install the selected driver.

13.

After the driver installation has finished, reboot the system.

14.

Reboot the system again to load the AICU160.ADD driver.