Specifications

h. Display assembly (see Display assembly on page 60)
i. Top Cover (see
Top cover on page 66)
j. Heat sink and fan (see
Heat sink and fan on page 75)
Remove the RJ-45 (network) jack:
1. Disconnect the RJ-45 (network) cable from the system board (1) and remove the tape (2) that
secures the cable to the base enclosure.
2. Lift the RJ-45 (network) jack (3) straight up from the retention clips to remove it.
Reverse this procedure to install the RJ-45 (network) jack.
78 Chapter 4 Removal and replacement procedures