Specifications

●
RJ-45 (network) cable (see
RJ-45 (network) jack on page 77)
●
Processor (see
Processor on page 79)
Remove the system board:
1. Position the base enclosure, with the front toward you.
2. Lift the power connector (1) from the retention clips in the base enclosure and remove the power
cable (2) from the routing clips.
3. Remove the battery connector board (1).
4. Remove the two Phillips PM2.5×3.0 screws (2) that secure the optical drive connector board to
the base enclosure.
5. Remove the Phillips PM2.5×3.0 screw (3) that secures the system board to the base enclosure.
82 Chapter 4 Removal and replacement procedures