Computer User's Guide

94 user’s guide
• To release an optical drive or diskette drive from the chassis of the 8000
series, slide the drive lock mechanism (1) to unlock the drive in the drive
bay and pull the drive out of the drive bay (2).
removing an optical or diskette drive from the 8000 series
• To release a hard disk drive from the chassis of the 8000 series, slide the
drive lock mechanism (1) to unlock the drive in the drive bay, remove the
metal drive shield (2) by pressing and lifting the two tabs on one side of the
shield, and then pull the drive out of the drive bay (3).
3
1
4
2
removing a hard disk drive from the 8000 series
5 For both the S0000 and 8000 series, if you are replacing the old drive with a
new drive, remove the four screws (4) (two on each side) from the old drive.
You need these screws to install the new drive.
NOTE: If you have the S0000 series, and you removed a 7-In-1 memory card
reader, continue to step 7; otherwise, you are finished with the task of
removing a drive from the chassis.
If you have the 8000 series, and you removed a hard disk drive, a 7-In-1
memory card reader or an optical drive, you are also finished with this task. If
you have the 8000 series, and you removed a diskette drive, continue to
step 6.