User Guide
Table Of Contents
- Contents
- Product Description
- Troubleshooting
- Illustrated Parts Catalog
- Removal and Replacement Preliminaries
- Removal and Replacement Procedures
- 5.1 Serial Number
- 5.2 Disassembly Sequence Chart
- 5.3 Preparing the Computer for Disassembly
- 5.4 Computer Feet
- 5.5 Memory Expansion Board
- 5.6 Mini PCI Communications Board
- 5.7 Disk Cell RTC Battery
- 5.8 Connector Cover
- 5.9 LED Cover
- 5.10 Keyboard
- 5.11 Heat Spreader
- 5.12 Processor
- 5.13 Display
- 5.14 Palm Rest
- 5.15 Diskette Drive
- 5.16 TouchPad Components
- 5.17 Display Release Assembly
- 5.18 Charger Board
- 5.19 Speaker Assembly
- 5.20 Top Cover
- 5.21 Fan
- 5.22 System Board
- 5.23 Modem Cable
- Specifications
- Connector Pin Assignments
- Power Cord Set Requirements
- Screw Listing
- Index
5–38 Maintenance and Service Guide
Removal and Replacement Procedures
8. Lift the front edge of the palm rest and swing it up and
back
1
until it rests on the top cover (Figure 5-30).
9. Release the ZIF connector to which the diskette drive cable is
attached
2
and disconnect the diskette drive cable
3
from the
system board.
10. Release the ZIF connector to which the system board-
to-TouchButton board cable is attached
4
and disconnect the
cable
5
from the TouchButton board.
Figure 5-30. Removing the Palm Rest
11. Remove the palm rest from the base enclosure.
Reverse the preceding procedures to install the palm rest.
272638-001.book Page 38 Thursday, July 25, 2002 4:21 PM