User Guide
Table Of Contents
- Contents
- Product Description
- Troubleshooting
- Illustrated Parts Catalog
- Removal and Replacement Preliminaries
- Removal and Replacement Procedures
- 5.1 Serial Number
- 5.2 Disassembly Sequence Chart
- 5.3 Preparing the Computer for Disassembly
- 5.4 Computer Feet
- 5.5 Memory Expansion Board
- 5.6 Mini PCI Communications Board
- 5.7 Disk Cell RTC Battery
- 5.8 Connector Cover
- 5.9 LED Cover
- 5.10 Keyboard
- 5.11 Heat Spreader
- 5.12 Processor
- 5.13 Display
- 5.14 Palm Rest
- 5.15 Diskette Drive
- 5.16 TouchPad Components
- 5.17 Display Release Assembly
- 5.18 Charger Board
- 5.19 Speaker Assembly
- 5.20 Top Cover
- 5.21 Fan
- 5.22 System Board
- 5.23 Modem Cable
- Specifications
- Connector Pin Assignments
- Power Cord Set Requirements
- Screw Listing
- Index
Removal and Replacement Procedures
Maintenance and Service Guide 5–43
7. Remove the four TM2.5 × 5.0 screws
1
that secure the
TouchPad, TouchButton board, and TouchPad bracket to the
palm rest (Figure 5-34).
8. Remove the TouchPad bracket
2
, TouchButton board
3
, and
TouchPad
4
from the palm rest.
Figure 5-34. Removing the TouchPad Components
5.17 Display Release Assembly
✎
Display release assemblies are available with carbon finish for
Evo Notebook N1005 models and silver finish for Presario 900
models, and are included in the Miscellaneous Plastics/Hardware
Kit, spare part number 285541-001.
1. Prepare the computer for disassembly (Section 5.3).
2. Remove the palm rest (Section 5.14).
3. Turn the palm rest bottom side up with the speaker grilles
facing forward.
272638-001.book Page 43 Thursday, July 25, 2002 4:21 PM