User Guide
Table Of Contents
- Contents
- Product Description
- Troubleshooting
- Illustrated Parts Catalog
- Removal and Replacement Preliminaries
- Removal and Replacement Procedures
- 5.1 Serial Number
- 5.2 Disassembly Sequence Chart
- 5.3 Preparing the Computer for Disassembly
- 5.4 Computer Feet
- 5.5 Memory Expansion Board
- 5.6 Mini PCI Communications Board
- 5.7 Disk Cell RTC Battery
- 5.8 Connector Cover
- 5.9 LED Cover
- 5.10 Keyboard
- 5.11 Heat Spreader
- 5.12 Processor
- 5.13 Display
- 5.14 Palm Rest
- 5.15 Diskette Drive
- 5.16 TouchPad Components
- 5.17 Display Release Assembly
- 5.18 Charger Board
- 5.19 Speaker Assembly
- 5.20 Top Cover
- 5.21 Fan
- 5.22 System Board
- 5.23 Modem Cable
- Specifications
- Connector Pin Assignments
- Power Cord Set Requirements
- Screw Listing
- Index
Removal and Replacement Procedures
Maintenance and Service Guide 5–45
3. Remove the three TM2.5 × 5.0 screws
1
that secure the
charger board to the base enclosure (Figure 5-36).
4. Lift the front edge of the charger board shield
2
until it clears
the base enclosure, then slide the shield forward to remove it.
5. Lift up on the back edge of the charger board
3
to disconnect
it from the system board.
6. Remove the charger board from the base enclosure.
Figure 5-36. Removing the Charger Board
Reverse the preceding procedures to install the charger board.
272638-001.book Page 45 Thursday, July 25, 2002 4:21 PM