User Guide
Table Of Contents
- Contents
- Product Description
- Troubleshooting
- Illustrated Parts Catalog
- Removal and Replacement Preliminaries
- Removal and Replacement Procedures
- 5.1 Serial Number
- 5.2 Disassembly Sequence Chart
- 5.3 Preparing the Computer for Disassembly
- 5.4 Computer Feet
- 5.5 Memory Expansion Board
- 5.6 Mini PCI Communications Board
- 5.7 Disk Cell RTC Battery
- 5.8 Connector Cover
- 5.9 LED Cover
- 5.10 Keyboard
- 5.11 Heat Spreader
- 5.12 Processor
- 5.13 Display
- 5.14 Palm Rest
- 5.15 Diskette Drive
- 5.16 TouchPad Components
- 5.17 Display Release Assembly
- 5.18 Charger Board
- 5.19 Speaker Assembly
- 5.20 Top Cover
- 5.21 Fan
- 5.22 System Board
- 5.23 Modem Cable
- Specifications
- Connector Pin Assignments
- Power Cord Set Requirements
- Screw Listing
- Index
Removal and Replacement Procedures
Maintenance and Service Guide 5–15
1. Prepare the computer for disassembly (Section 5.3).
2. Turn the computer bottom side up with the rear panel facing
forward.
3. Remove the PM2.5 × 4.0 screw
1
that secures the mini PCI
compartment cover to the base enclosure (Figure 5-12).
4. Slide the cover to the left
2
.
5. Lift the left edge of the cover and swing it to the right
3
.
6. Remove the cover
4
.
Figure 5-12. Removing the Mini PCI Communications
Slot Cover
✎
Mini PCI compartment covers are available with carbon finish for
Evo Notebook N1005 models and silver finish for Presario 900
models, and are included in the Miscellaneous Plastics/Hardware
Kit, spare part number 285541-001.
272638-001.book Page 15 Thursday, July 25, 2002 4:21 PM