User Guide
Table Of Contents
- Contents
- Product Description
- Troubleshooting
- Illustrated Parts Catalog
- Removal and Replacement Preliminaries
- Removal and Replacement Procedures
- 5.1 Serial Number
- 5.2 Disassembly Sequence Chart
- 5.3 Preparing the Computer for Disassembly
- 5.4 Computer Feet
- 5.5 Memory Expansion Board
- 5.6 Mini PCI Communications Board
- 5.7 Disk Cell RTC Battery
- 5.8 Connector Cover
- 5.9 LED Cover
- 5.10 Keyboard
- 5.11 Heat Spreader
- 5.12 Processor
- 5.13 Display
- 5.14 Palm Rest
- 5.15 Diskette Drive
- 5.16 TouchPad Components
- 5.17 Display Release Assembly
- 5.18 Charger Board
- 5.19 Speaker Assembly
- 5.20 Top Cover
- 5.21 Fan
- 5.22 System Board
- 5.23 Modem Cable
- Specifications
- Connector Pin Assignments
- Power Cord Set Requirements
- Screw Listing
- Index
5–18 Maintenance and Service Guide
Removal and Replacement Procedures
5.8 Connector Cover
✎
Connector covers are available with carbon finish for Evo
Notebook N1005 models and silver finish for Presario 900
models, and are included in the Miscellaneous Plastics/Hardware
Kit, spare part number 285541-001.
1. Prepare the computer for disassembly (Section 5.3).
2. Turn the computer bottom side up with the rear panel facing
forward.
3. Remove the two TM2.5 × 5.0 screws
1
that secure the
connector cover to the base enclosure (Figure 5-15).
4. Open the connector cover
2
.
5. Remove the connector cover from the base enclosure
3
.
Figure 5-15. Removing the Connector Cover
Reverse the preceding procedures to install the connector cover.
272638-001.book Page 18 Thursday, July 25, 2002 4:21 PM