User`s guide

o Material handling packages
o Conductive plastic bags
o Conductive plastic tubes
o Conductive tote boxes
o Metal tote boxes
o Opaque shielding bags
o Transparent metallized shielding bags
o Transparent shielding tubes
SERVICE CONSIDERATIONS
Listed below are some of the considerations that should be kept in mind
during the disassembly and assembly of the computer.
Tool Requirements:
o Flat bladed screwdriver
o Torx T8 screwdriver (included in 130619-001)
o Hex socket driver (3/16)
o 25 Pin printer loopback plug (included in 100767-001)
o 9 Pin serial loopback plug (included in 100767-001)
o Cross recess (Phillips) screwdriver (included in 130619-001)
o Trackball tool (spare part number 194041-001)
o Case utility tool (spare part number 119070-001 and included in
10076-001)
o PCMCIA external diskette drive (part number 190533-001)
o Preloaded application diskettes (Compaq Order Center, 1-800-952-7689)
Screws
The screws used in these products are not interchangeable. If an incorrect
screw is used during the reassembly process, it could cause damage to the
unit. Compaq strongly recommends that all screws removed during the
disassembly process be kept with the part that was removed, then returned
to their proper locations.
IMPORTANT: As each subassembly is removed from the computer, it should be
placed away from the work area to prevent damage.