User`s guide

To replace the LCD panel, follow these steps:
1. Remove the pressure sensitive adhesive backing from the back of the
display cable. Align the holes in the cable with the mounting pins on
the display enclosure.
2. Connect the display cable to the LCD panel with the ZIF connector.
3. Lay the LCD panel into the display enclosure with the bottom of the
display cable exposed.
4. Secure the LCD panel with three screws to the display enclosure.
5. Secure the support bracket with one screw in the bottom right corner of
the display enclosure.
Latch, Clutch, Pin, and Display Shield
To remove and replace the latch from the middle of the display enclosure,
the clutch, pin, and the display shield, follow these steps (Figure 3-21):
1. Remove the display bezel (Section 3.5).
2. Using a small flat bladed screwdriver, remove the spring from the latch.