QuickSpecs

HP-UX support
HP-UX supportHP-UX support
HP-UX support The MSA1000 for HP-UX only supports active/active dual controller configurations or single controller
configurations. Two controller, active/passive configurations are not supported. HP-UX support is
heterogeneous with Windows and Linux. Command Line Interface (CLI) is used for configuration and
Event Monitoring Service (EMS) for monitoring. Root/Boot/Dump/Swap/Install is also supported.
Command Line Interface (ACU/CLI) is used for configuration and Event Monitoring Service (EMS)
for monitoring.
Root/Boot/Dump/Swap/Install is supported.
PV Links is supported for multi (HBA) path / single controller (2 HBAs) configurations.
Fabric and direct Connect are supported
HP-UX 11.11, 11.23, and 11.31 PA-RISC and Itanium
SCO UnixWare and
SCO UnixWare andSCO UnixWare and
SCO UnixWare and
OpenServer
OpenServerOpenServer
OpenServer
HP's MSA1000 SAN solution is available today to run on SCO UnixWare 7.1.3 and 7.1.4 and SCO
OpenServer 6.0.0. The MSA1000 with a single controller or dual/active controllers may be connected to
a ProLiant server with SCO UnixWare in one of the below described manners:
Direct Attach
Through an internal switch
Software Certifications
Software CertificationsSoftware Certifications
Software Certifications Microsoft Cluster Server Certification
HP Serviceguard for Linux & HP-UX
Hewlett Packard Data Protector
VERITAS Backup Exec and NetBackup
Legato NetWorker for Windows
SteelEye LifeKeeper for Linux Certification
Please refer to compatibility matrix at http://www.hp.com/go/msa1000 for complete configuration
support.
QuickSpecs
HP StorageWorks 1000 Modular Smart Array QuickSpec
HP StorageWorks 1000 Modular Smart Array QuickSpecHP StorageWorks 1000 Modular Smart Array QuickSpec
HP StorageWorks 1000 Modular Smart Array QuickSpec
for Intel, AMD, PA-RISC
for Intel, AMD, PA-RISCfor Intel, AMD, PA-RISC
for Intel, AMD, PA-RISC
Software Components
DA - 12624 Worldwide — Version 6 — October 5, 2007 Page 10