Setup guide

19
Installing the Edit Display Controller Board
IBM ships the IntelliStation Z Pro 6866 system with the AGP board
installed in a dedicated slot on the system board as the video board in
your system. NewsCutter is designed to work with the edit
display
controller board included in your kit. The edit display controller board
and the AGP board cannot be installed in the system at the same time.
NewsCutter Release 2.x uses the edit display controller board installed
in a PCI slot to connect the monitor. Use Ta ble 2 or Tabl e 3 to identify
the PCI slot where the edit display controller board needs to be
installed. Figure 3 shows the edit display controller board.
n
The edit display controller board that is included in the kit for the Compaq
Professional Workstation AP500 system will have heat sinks attached to two
components on the board.
Figure 3 Edit Display Controller Board Connection
c
Before installing the edit display controller board, remove the AGP
board from the system.
To install the edit display controller board:
1. Turn off the Avid system and remove the power cord.
Cable to digital media board set
0474101A.fm Page 19 Thursday, December 14, 2000 4:25 PM