Setup guide

24
To install the fan:
1. Loosen the two wing nuts and make sure the movable extension is
as far back as it can go as shown in Figure 5.
2. Place the two fan tabs, located at the rear of the fan, into the lowest
holes of the rear airflow grate. There is an illustration on the fan
that shows the actual insertion points for the tabs (see Figure 5).
Figure 5 Fan Tab Location
3. Gently press the fan portion onto the board set.
4. While holding the fan portion in place so the tabs don’t move,
extend the movable extension toward the front of the system
making sure the middle piece of the extension goes under the
plastic while the two outer pieces go over the top (see Figure 6).
Insertion
illustration
Tabs
Rear airflow
grate
Movable
extension
Wing nuts
0474101A.fm Page 24 Thursday, December 14, 2000 4:25 PM