Setup guide

27
3. Remove any audio cables connected to the Avid Meridien I/O
box.
4. Loosen (but do not remove) the captive thumbscrews on each side
of the two-channel audio I/O board. Figure 8 shows the location
of the captive thumbscrews.
Figure 8 Avid Meridien I/O Box Thumbscrews
5. Use the captive thumbscrews to pull the board out of its slot.
6. Repeat step 4 and step 5 to remove the blank panel (top).
7. Install the 2 two-channel audio I/O boards included with your kit
into the open slots in the Meridien I/O box.
Make sure the board edges (or the metal base of the audio I/O
board) are in the guide rails before you slide the board into the
Meridien I/O box (see Figure 9).
Thumbscrews ThumbscrewsTwo-channel
audio I/O board
Blank panel
0474101A.fm Page 27 Thursday, December 14, 2000 4:25 PM