Troubleshooting guide

1. Remove the PC Card clip. Refer to "Removing the PC Card Clip" in this

section.

2. Using the connector removal tool, compress the set of clips on the

right and left sides of the rails. This allows the rails to be shifted

right or left for removal.

3. Slide the rails out of the header (Figure 5-54).

4. To replace the PC Card rails, reverse the previous steps. The PC Card

rails go under the edge of the header.

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<

Be sure not to overtighten any screws or the PC Cards may be difficult to

insert and eject.

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<

PC Card (PCMCIA) Ejection Levers and Pin

This section contains removal and replacement procedures for the PC Card

ejection levers and pin.

To remove the PC Card ejection levers and pin, follow these steps:

1. Turn the computer off and remove all external devices, including the

battery pack and the AC Adapter Remove the diskette and PC Card if

battery

pack

and

the

Adapter

Remove

the

diskette

and

Card