User Guide

5-28 Removal and Replacement Procedures

4. Remove the screw that secures the memory expansion compartment cover to the

computer

(Figure 5-24).

NOTE: If the computer was shipped with a preinstalled memory expansion board, the

cover is attached with a tamper-resistant Torx T-10 memory security screw. Use the

Torx T-10 screwdriver included with the computer to remove and reinsert this

screw.

If the computer was not shipped with preinstalled memory expansion boards, the

cover is attached with a standard Torx T-8 screw. Use a Torx T-8 screwdriver to

remove and reinstall the screw.

5. Slide the cover to the left

and lift the left edge up to remove it.

Figure 5-24. Removing the Memory Expansion Compartment Cover