QuickSpecs

If this occurs, please use Library
and Tape Tools to perform further
diagnosis or contact HP support
for further advice.
Error Condition
Error ConditionError Condition
Error Condition
Signal
SignalSignal
Signal
Off On steady HP DAT drives perform a comprehensive
self-test during power-up. If a hard error
causes the self-test to fail, the clean light
changes to steady amber. Run HP
Library & Tape Tools to help diagnose
the problem.
OBDR Signal
OBDR SignalOBDR Signal
OBDR Signal Pulsing (2
flashes
followed
by a
pause)
The tape drive is in disaster recovery
mode, restoring the operating system.
© Copyright 2011 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice.
Microsoft and Windows are US registered trademarks of Microsoft Corporation. Intel is a US registered trademark of Intel
Corporation. Unix is a registered trademark of The Open Group.
The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and
services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial
errors or omissions contained herein.
For tape drives and media, 1 GB = 1 billion bytes. Actual formatted capacity is less.
QuickSpecs
HP StorageWorks DAT Tape Drives
HP StorageWorks DAT Tape DrivesHP StorageWorks DAT Tape Drives
HP StorageWorks DAT Tape Drives
Technical Specifications
DA - 11883 Worldwide — Version 35 — April 29, 2011 Page 34