Specifications

5–38 Maintenance and Service Guide
Removal and Replacement Procedures
8. Lift the front edge of the palm rest and swing it up and
back 1 until it rests on the top cover (Figure 5-30).
9. Release the ZIF connector to which the diskette drive cable is
attached 2 and disconnect the diskette drive cable 3 from the
system board.
10. Release the ZIF connector to which the system board-
to-TouchButton board cable is attached 4 and disconnect the
cable 5 from the TouchButton board.
Figure 5-30. Removing the Palm Rest
11. Remove the palm rest from the base enclosure.
Reverse the preceding procedures to install the palm rest.
272638-002.book Page 38 Wednesday, November 27, 2002 4:52 PM