Specifications

5–58 Maintenance and Service Guide
Removal and Replacement Procedures
2. Position the base enclosure so the rear panel is facing
toward you.
3. Remove the following screws:
❏ Two T8M2.0×6.0 screws 1 from the rear panel
❏ One T8M2.0×4.0 screw 2 in the upper right corner of
the system board
❏ One T8M2.0×4.0 screw 3 in front of the hard drive bay
❏ One T8M2.0×4.0 screw 4 in the lower left corner of
the system board
4. Use a 5.0-mm socket to remove the two M2.0×9.0
standoffs 5 that secure the system board to the base
enclosure.
Removing the System Board Screws