User`s guide

2-2 Pass-Through Mechanism Expansion Kit Installation Instructions
Compaq Confidential – Need to Know Required
Writer: Don Kaplan Project: Pass-Through Mechanism Expansion Kit Installation Instructions Comments:
Part Number: ER-TL881-EA. A01/138255-001 File Name: C-CH2 UP.DOC Last Saved On: 5/13/99 10:01 AM
■
Angle brackets (7)
■
L-shaped nut plates (8).
1
2
3
4
4
7
6
6
5
6
8
8
8
4
8
5
5
SHR-1233
Figure 2-1. Mechanism External Parts
NOTE: The slide extensions, (6) in Figure 2-1, are not enclosed with the mechanism
parts. They are supplied as part of the installation hardware for the slides that come with
each of the modules.
The rails for each rack type might be different but the mounting scheme is the same.
If you are installing a module, follow the instructions for installing rack slides
that appear in both the System User’s Guide and the Service Manual for the
TL881 MiniLibrary system. After the rack slides and the slave modules are in
place, and after the mechanism is assembled, you will install the mechanism in
the rack by attaching the support braces (5) to the slide extensions (6) using
the angle brackets (7) and L-shaped nut plates (8).
The internal parts you will need to recognize during assembly, the car and the
belt block, are shown in Figures 2-2 and 2-3; Figure 2-3 locates the belt block
(1) and the captive screws (2).