User`s guide

Upgrade Procedure 2-5
Compaq Confidential – Need to Know Required
Writer: Don Kaplan Project: Pass-Through Mechanism Expansion Kit Installation Instructions Comments:
Part Number: ER-TL881-EA. A01/138255-001 File Name: C-CH2 UP.DOC Last Saved On: 5/13/99 10:01 AM
1
2
1
3
4
5
1
SHR-1236
Support brace; Motor section drive; Extension section; Tie bar;
Base section.
Figure 2-4. Assembled Mechanism
Assembling the Mechanism
You need a clean, flat work area such as a table or work bench. The surface
should be long enough to support the full height of the mechanism. The height
is equal to the height of the stack of modules in your system plus any gaps you
intend to include in the stack.
Do the following steps to assemble the mechanism. Even though in most cases
you are adding to a previously-assembled mechanism, it will help if you take a
few minutes to read this section and the next section on installing the belt
before you proceed to the section entitled Adding to an Existing Mechanism.