User`s guide

Upgrade Procedure 2-9
Compaq Confidential – Need to Know Required
Writer: Don Kaplan Project: Pass-Through Mechanism Expansion Kit Installation Instructions Comments:
Part Number: ER-TL881-EA. A01/138255-001 File Name: C-CH2 UP.DOC Last Saved On: 5/13/99 10:01 AM
SHR-1239
Figure 2-7. Belt Ends
7. Locate the belt block and the four screws that hold the belt retaining
plates to the block (Figure 2-8). Loosen the four screws and slide the
ends of the belt under the plates until they engage the teeth on the block;
both ends of the belt should be visible through the gap between the
plates. Set the belt so there is only a small space between the ends of the
belt (about 1/32").
8. Tighten the four screws that hold the belt retaining plates.
9. Pull out the Allen wrench or the paper clip from the base section; now
the proper tension is applied to the belt.