User`s guide

Upgrade Procedure 2-11
Compaq Confidential – Need to Know Required
Writer: Don Kaplan Project: Pass-Through Mechanism Expansion Kit Installation Instructions Comments:
Part Number: ER-TL881-EA. A01/138255-001 File Name: C-CH2 UP.DOC Last Saved On: 5/13/99 10:01 AM
SHR-1198
1
2
Figure 2-9. Aligning the Captive Screws with the Belt Block
16. Begin to tighten the captive screws. When both screws are threaded into
the belt block partially, release the belt and then continue to tighten the
screws until the belt block is seated firmly against the car bracket. Close
the car door and secure it.
17. Using nylon button rivets install safety covers over any exposed
mechanism sections that will not be covered by modules.
18. If you have not already installed all new modules, go to the section
entitled Mounting the Module Rack Slides in the System User’s Guide
that was enclosed with the module.
NOTE: The 10-32 pan head screws and lock washers required to mount the slides in the
rack are included in Kit 606619-001, which is one of the items in this kit.
Adding Sections to an Existing
Mechanism
Before you do this procedure read through the two preceding sections,
Assembling the Mechanism and Installing the Belt; it will help you to