User guide

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-2
Installing the Hub
Writer:
Chris Seiter
Project:
Installing the Hub
Comments:
299440-001
File Name:
2824_3.DOC
Last Saved On:
6/26/97 11:00 AM
To attach the brackets, follow these steps:
1. Remove the two screws from the left and right side of the hub. (These
screws are extras and are not needed to install the
mounting brackets.)
2. Position the bracket as shown in Figure 3-1 and secure it with the
smaller bracket screws. Then attach the remaining bracket to the other
side of the hub.
Figure 3- 1.
Attaching the Mounting Brackets
3. After you attach both mounting brackets, position the bracket slots over
the desired holes on the rack (Figure 3-2). Then insert and tighten the
supplied rack-mount screws.
Figure 3- 2.
Positioning the Hub in a Rack