User guide

Compaq StorageWorks RAID Array 4000 User Guide
To install the rack-mountable RA4000 in a 19-inch rack, you must perform
these steps.
1. Remove any blank panels from the chosen rack location.
2. Use the supplied template to mark the location of the mounting
hardware on the vertical mounting rails of the rack cabinet. One side of
the template is used for the front rails of the rack and the other side for
the rear rails. Instructions are included on the template.
3. If there is a rack component immediately below the position of the
storage system, place the template against the front rails and rest it on
the top of the previously installed component.
4. Push back the tabs in the top of the template (marked ★) and place them
in the correct holes in the mounting rails. The hole pattern indicated on
the sides of the template should match the hole pattern in the rails.
TROJ032.EPS
M
C
M
M
C
M
Figure 2-1. Measuring with the template
5. Use a pencil to outline the square holes in the front mounting rails
indicated on the template (marked M and C) that will be used to secure
the mounting brackets and the storage system to the rack cabinet.