User guide

Compaq StorageWorks RAID Array 4000 User Guide
5. Twist the latch that is holding the daughterboard to the RA4000
Controller 90 degrees to allow the standoff to pull through the controller
board 1.
6. Carefully pull the daughterboard away from the controller board 2,
unplugging the signal connectors.
1
2
Figure 4-19. Removing the daughterboard
7. Align the connectors of the new daughterboard with the controller
board; plug the daughterboard onto the RA4000 Controller 1. Be sure
the connectors are fully mated by squeezing the boards together at the
connector side.
8. Align the plastic standoff on the daughterboard with the slot in the
controller board. Push it through and rotate the latch 90 degrees to lock
the board in place 2.