User guide

Troubleshooting
2
1
Figure 4-20. Installing the daughterboard
9. With the daughterboard installed, push the RA4000 Controller in as far
as it will go 1.
10. Close both latches against the rear panel 2. The levers on each latch
should catch behind the metal lip, drawing the board into place and
securing it.
1
2
2
Figure 4-21. Replacing the RA4000 Controller
11. Replace the GBIC and reconnect the Fibre Channel cable.
12. If the system was powered down, power on the RA4000, and then
power on the attached servers.