User's Manual

Enter your client’s hardware network address, or press Return if the
default is correct. The default is the client’s existing hardware address.
See Section 2.6 for information about determining a system’s hardware
network address.
You see a message similar to the following:
Client client01 has been modified.
*** RIS Utility Main Menu ***
a) ADD a client
d) DELETE software products
i) INSTALL software products
l) LIST registered clients
m) MODIFY a client
r) REMOVE a client
s) SHOW software products in remote installation environments
x) EXIT
Enter your choice:
______________________ Note _______________________
To modify a RIS client’s IP or routing information, remove the
client and add it with the modified information.
6.5 Removing RIS Clients
To remove a RIS client, follow these steps:
1. Log in as root or use the su command to gain superuser privileges.
2. Start the ris utility:
# /usr/sbin/ris
You see the RIS Utility Main Menu:
*** RIS Utility Main Menu ***
Choices without key letters are not available.
a) ADD a client
d) DELETE software products
i) INSTALL software products
l) LIST registered clients
m) MODIFY a client
r) REMOVE a client
s) SHOW software products in remote installation environments
x) EXIT
Managing RIS Clients and Environments 6–9