Installation manual

Santa Fe CN-M5

Installation manual

Caution – Documentation is an aid to successful installation. No liability is assumed for incorrect installation. If

unsure of expertise required, please consult a qualified installation tech.

1- The black locking tab in the TRIP module is

carefully lifted to allow the ribbon cable to be

installed into the TRIP module.

2- The flat ribbon contacts (silver) need to be

facing down (to make contact) and the blue

needs to face up. The ribbon must be

CAREFULLY but firmly pushed into the TRIP

connector, ensuring it is parallel and has no

bends or tears.

3- Then fold down gently the locking tab.

4- Then carefully install the rubber retainer,

inserting the bottom piece first into place to

ensure the locking tab and therefore ribbon

cable does not disengage. Caution: Make sure

to insert the bottom of the rubber block first

otherwise the locking tab may fold back and

brake. If the locking tab is broken; stop the

installation immediately and contact support.