Installation manual

Santa Fe CN-M5
Installation manual
Caution – Documentation is an aid to successful installation. No liability is assumed for incorrect installation. If
unsure of expertise required, please consult a qualified installation tech.
77
1- Prior Installing the trip module into the radio
chassis, connect the trip module video & signal
cable at the back of the trip module as shown.
Then guide the trip module inside the radio
body, make sure all the wires are directed to the
front of the radio chassis.
See bill of material
2- Locate the wire labeled GND from the
wires brought to the front; make a loop and
attach the terminal to the lower right
corner of the radio chassis using one of the
screws removed from the factory faceplate.
Once this step completed, return to
the section you came from.