Hardware Guide

hardware guide - wpj419
Last Updated: 13/05/2022
Copyright © Compex Systems. All rights reserved. COMPEX and the COMPEX logo, are registered trademarks of Compex Systems.
While every eort is made to ensure the information is accurate,
Compex does not accept liability for any errors or mistakes that may arise. All specications are subject to change without notice.
Compex Systems Pte Ltd | www.compex.com.sg | ([phone] | [e-mail] | Last Updated: 13/05/2022 SL, LL
MiniPCIe slot ( 9.9mm height mini-PCIe slot)
Top side Bottom side
1 PCIE_WAKE_UP_N 2 +3.3V
3 PWRDN_WIFI 4 GND
5 NC 6 NC
7 PCIE_CLK_REQ_N 8 NC
9 GND 10 NC
11 PCIE_CLK- 12 NC
13 PCIE_CLK+ 14 NC
15 GND 16 NC
Mechanical Key
17 NC 18 GND
19 NC 20 NC
21 GND 22 PCIE_RST
23 PCIE_RX- 24 +3.3V
25 PCIE_RX+ 26 GND
27 GND 28 NC
29 GND 30 NC
31 PCIE_TX- 32 NC
33 PCIE_TX+ 34 GND
35 GND 36 NC
37 NC 38 NC
39 +3.3V 40 GND
41 +3.3V 42 NC
43 NC 44 NC
45 +5V 46 NC
47 +5V 48 NC
49 +5V 50 GND
51 +5V 52 +3.3V
miniPCIe Slot Pin Assignment
Ethernet 0 Pin Assignment
Pin Signal
1 TX+/POE+
2 TX-/POE+
3 RX+/POE-
4 TX+/POE+
5 TX-/POE+
6 RX-/POE-
7 RX+/POE-
8 RX-/POE-
FCC Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interfer-
ence that may cause undesired operation.
Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
RF Exposure
The antennas used for this transmitter must be installed to provide a separa-
tion distance of at least 20 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter.