Installation guide

Compro TN2200 - Quick Installation Guide

Installation

Without Using Wall Mount Base

1. Use the supplied hex key to remove the top cover.

Rubber O-ring

2. Drill 2 mounting holes on the mounting surface. The 2 screw holes should be

spaced exactly 80 mm (3.15 inch) apart to correspond to the position of mount-

ing holes on the camera. (Or use the supplied drill template B to drill the mount-

ing holes.) Then drill a cable hole if you need to run the cable through the mount-

ing surface.

Rubber O-ring

80 mm

Cable Hole

3. Fix the camera to the mounting surface with the supplied self-tapping screws.

Make sure you use a supplied rubber O-ring in between the screws and the screw

holes (as circled) to avoid moisture entering the casing. Feed the camera’s cable

through the cable hole. Lastly, re-attach the camera’s top cover and secure the

screws tightly with the supplied hex key.