User guide

ENTEGRIS, INC. Customer Service Tel. 763-502-0200 Customer Service Fax 763-502-0300 41
NT® INTEGRATED FLOW CONTROLLER WITH DEVICENET™ COMMUNICATION USER GUIDE
ATT. RE- SUP- ACCESS DATA ATTRIBUTE
ID QUIRED PORTED RULE NV NAME TYPE DESCRIPTION VALUES
9 Optional Yes Set NV Warning BOOL Enables the 0 = Disable [default]
Enable setting of the 1 = Enable
Warning status
bits
10 Optional Yes Get NVC Full Same as The value of = 6000
hex
Scale Value Full Scale
for the sensor
17 Optional Yes Set NV Alarm Same as Determines the [default] =
Trip Value value above Maximum value
Point which an for its data type.
High Alarm Condition
will occur
18 Optional Yes Set NV Alarm Same as Determines the [default] =
Trip Value value below Minimum value
Point which an for its data type.
Low Alarm Condition
will occur
21 Optional Yes Set NV Warning Same as Determines the [default] =
Trip Value value above Maximum value
Point which a Warning for its data type.
High Condition
will occur
22 Optional Yes Set NV Warning Same as Determines the [default] =
Trip Value value below Minimum value
Point which a Warning for its data type.
Low Condition
will occur
25 Optional Yes Set NV Safe USINT Specifies the 0 = Zero [default]
State behavior for 1 = Full Scale
the value for 2 = Hold last value
states other 3 = Use safe value
than Execute 4 = Continue sensing
5-50 = Reserved
51-99 =
Device specific
100-255 =
Vendor specific
26 Optional Yes Set NV Safe Same as The value to be [default] = 0
Value Value used for Safe State
= Safe Value
27 Optional Yes Set NV Autozero BOOL Enables the 0 = Disable
Enable Autozero** 1 = Enable [default]
NOTE: This
default is a
DeviceNet™
compliance
variance.
28 Optional Yes Get V Autozero BOOL Indicates the 0 = Inactive
Status status of the 1 = Active
automatic
nulling**
** With Autozero enabled, upon Set point = 0, the device will close the valve then wait a delay period before
beginning the sensor nulling process. The Autozero status can be monitored to detect when the nulling process
actually begins.
ENT48906 10/15/04 8:12 AM Page 41