Service manual

FIGURE 1
S-2
LOCK CODING
The safest method to code the lock is to remove it and secure it in a vise or similar tool. The
lock can also be recoded in the handle.
(For the following steps refer to Figure 2)
STEP 1
Insert key into lock. Insert pin into hole in cap.
STEP 2:
To release cap, push pin in firmly and rotate key to right slot position. Remove cap and key as
one unit.
STEP 3:
Using magnet end of loading tool, remove all seven tumblers.
STEP 4:
Slip preloaded coder on lock. Place loading tool into coder. Coder and tool will mount in one
direction only. Press new tumblers firmly into place.
STEP 5:
Remove coder and tool as one unit. Check to insure that all tumblers are in place. Replace
lock cap.
STEP 6:
Insert New key. Press cap in and rotate key counter clockwise left to locked position.