Service manual

Page 5
SECTION I: VENDOR INSTALLATION (CONT’D)
G. Door Support (Fig. 2)
The door support may be raised or lowered
by adding or removing shims, to insure that
the outer door closes squarely to the cabinet.
Raising or lowering the door support can also
insure proper alignment of the door latch.
FIGURE 2
H. Door Latch Alignment (Fig. 3)
After any door adjustment, the floating
Quicker Lock assembly should align itself automatically. The latch assembly is
adjustable. To adjust, loosen the latch bracket mounting screws, and raise or lower
the latch assembly into position, then tighten the mounting screws.
FIGURE 3
FIGURE 4
WARNING:
KEEP FINGERS AND OTHER OBJECTS OUT OF LOCK CAVITY
NOTE: Refer to the Appropriate Parts and Service Manual for Detailed
Instructions, Operating Principals, and Recommended Maintenance
Intervals and Procedures.