Service manual

SECTION VI: SUBSTITUTIONS AND MODIFICATIONS
GENERAL
Unauthorized changes or the substitution of unauthorized parts can compromise the
equipment designs. This can result in unsafe conditions for either the service personnel or
the equipment users. Always refer to the appropriate Parts and Service Manual for
replacement parts and maintenance instructions. If questions arise, contact the Technical
Services Department of the Vendo office in your area. (Consult the listing at the end of
this manual.)
When servicing the vending machine, always reassemble all components to their original
location and position. Maintain the correct routing for tubing, electrical wiring, etc.
Replace all clamps, brackets, and guides to their original locations. Replace all tubing,
sleeving, insulating material, and protective covers to their original condition.
WARNING:
VENDO EQUIPMENT HAS BEEN PROVIDED WITH APPROPRIATE
PROTECTIVE DEVICES TO PROTECT AGAINST THE POSSIBILITY OF
OVERHEATING AND FIRE, AS A RESULT OF EQUIPMENT OR
COMPONENT FAILURES. SUBSTITUTION, MODIFICATION, OR
BYPASSING OF SUCH PROTECTIVE DEVICES CAN CREATE
DANGEROUS CONDITIONS. PROTECTIVE CIRCUITS SHOULD NEVER
BE BYPASSED, AND FAILED PROTECTIVE DEVICES MUST BE
REPLACED ONLY WITH FACTORY-AUTHORIZED PARTS.
A. Service Cord Replacement
Vendo vending machines are furnished with unique power supply cords. If
replacement becomes necessary, consult the appropriate Parts and Services
Manual and order the correct replacement cord for the model of vending machine in
question. Do not use substitute replacement cords. Only authorized service
personnel with appropriate training should replace the vending machine service
cord. If a question should arise concerning which service cord to order, contact the
Technical Services Department of the Vendo office in your area for assistance.
Page 10