Service manual

READING A PARTS LIST
I ITEM NUMBER is found in two locations:
A. It is on the drawing plate, and identifies the part and its location;
B. The same number is in the parts lists and ties the two together.
II PART NUMBER is the part number that has been assigned to a specific part by
Vendo, for easier identification.
III QUANTITY REQUIRED relates to the amount required of a part, or will be indicated by
“A/R” as required to attach it to another part.
IV PART NAME AND DESCRIPTION is the general description for the part, for easier
identification when ordering a like part.
The example below will show how the parts are listed in the parts lists:
1. VEND MOTOR ASSEMBLY: This is the main assembly named, and any replaceable
parts will be indented below the assembly.
2. RETAINER CAM: This is an individual part, and will be indented. These indented
parts can be ordered separately, so you do not need to order the entire assembly.
3. Whenever an assembly is ordered, all the parts that are indented will be included in the
assembly. Any hardware will be listed next to their corresponding parts.
4. Any parts that may be ordered separately will not have any indented parts listed below
them.
“UNIVENDOR-2” VEND MOTOR ASSEMBLY
ITEM NO. PART NO. QTY REQ’D DESCRIPTION
1 133787-1 - VEND MOTOR ASSEMBLY
2 389401 1 RETAINER CAM
3 390360 1 TIMING CAM
4 388687 1 CARRIER SWITCH
5 388303 1 BASE SWITCH (SPACER)
6 340025-3 1 INSULATOR
7 388637 1 VEND MOTOR
8 V384341 2 PH TAP SCREW 4- 4 x 1 1/8
9 V801422 3 HH TAP SCREW 10- 16 x 1/2
If an asterisk is listed below the parts list, it is an indication that special information is noted.
There may be more than one (*) (**) (***) asterisk denoting special notes.
“UNIVENDOR-2” KIT LIST
A-1