Service manual

FIGURE 7 FIGURE 9
ALIGNMENT CHECKS
DOOR ROLLER CHECK:
The Door Roller assembly is raised or lowered by adding or removing shims, (see figure 7 ).
Raising or lowering the roller will help ensure the proper alignment of the door lockstud to the
cabinet latch.
DOOR ALIGNMENT CHECK:
After any door adjustment, the Quicker Lock should align itself automatically. If additional
adjustment is necessary, loosen mounting screws, (see Figure 8), raise or lower latch to the correct
position. Tighten mounting screws the floating nut of the Quicker Lock must be able to engage the
bolt of the T-handle.
REFRIGERATION AREA CHECK:
Check the position of the Condensation Pan, see Figure 9. The correct position of the Condensation
Pan is between the Compressor and the Condenser Fan Bracket. Be sure the Drain tube is clipped
to the pan and free of kinks. A loop must be maintained in the tubing. The loop prevents warm air
from reaching the evaporator area.
FIGURE 8
S-5