Service manual

LOADING INSTRUCTIONS
BASIC LOAD SET-UP:
The Univendor-2 machine is capable of vending a variety of product. The Chart on page 7 is a
basic guide for the load set-up of these products. Refer to the chart and the items in Figure 12 for
each product’s setting and kits. Installation Instruction are included with each kit. Call a service
representative for kits or further information.
Open upper and lower product cage assemblies at front of stack to load product in columns. Load
product evenly. Bottles are loaded with crown end placed toward the back of the column. After
filling columns, close product cage assemblies. In initial loading, prime the machine by advancing
the product into the buckets. To advance product, insert proper coins and push the selection button
of the column you wish to prime. When the bucket is loaded the column is ready to vend. Prime all
columns.
FIGURE 12
S-7