Service manual

THE VENDO COMPANY
7209 North Ingram Ave Fresno, CA 93650
Phone [phone] - Fax [phone]
VEC 5.1-1061 - 1067 Programming Guide
DOOR OPEN CONTROL SEQUENCE
1. Diagnostic Error Codes
2. Sales Information
3. Alternate Test Vend
4. Control Operation & Programming
PROGRAMMING CHECKLIST
NOTICE: Do not enter the programming modes of this control without
authorization and proper training.
The leading cause of vendor malfunction is a control board that is not properly
programmed. When installing a new board or when trying to trouble shoot a vendor that
is not operating as expected, follow these steps in the order listed.
1. Space to Sales (SSS). Confirm each selection has the correct column(s)
assigned. Confirm each column is assigned to at least one selection. As a
starting point, assign columns to selections using the Quick Set (SSSS) Mode
and pressing the last selection button (Selection 9 or 10 depending on model).
2. Options (OPTS) & (OPT 2). Check the settings for each of the different options.
As a starting point, set all options to factory settings.
3. Price Setting (COST). Set each selection to desired price from .00 (Free Vend)
to $99.95
4. Timer Control (TCTL). If an optional timing device or key switch is installed,
check that the selections are set as desired. (Be sure the optional timing device
is operating properly.)
5. When exiting “Service Modes” (i.e. actuating the door switch) you must wait 30
seconds before the vendor will accept coins or bills.
For detailed instructions, refer to the Service and Operation Manual or call the Technical
Services Department of The Vendo Company at 800-344-7216 or 559-439-
1770.